If you have never had turf installed, the process can seem like a mystery. In reality, it follows a steady sequence that most crews repeat on every job. Here is what a typical install looks like in Arvada yards, step by step, so you know what to expect.
What happens on artificial turf installation day?
On install day the crew marks the area, removes grass and soil, caps sprinklers, builds and compacts a crushed rock base, lays the turf with blades facing one direction, joins seams, secures edges and brushes in infill. Smaller yards may finish in a day, larger ones take a few. Clearing the yard, unlocking gates and sorting out pets and parking ahead of time keeps things moving.
Morning One: Marking and Digging
The crew arrives, walks the yard with you and marks the turf area with paint or flags. Sprinkler heads and lines are located, and buried utilities should already be marked. Then the digging starts. A sod cutter slices up the grass, and the crew removes a few inches of soil.
Removed sod and soil go into a trailer or dump truck. Sprinkler heads in the turf area are capped, and the crew checks the grade so the finished turf will sit at the right height next to patios and walks.
Building and Compacting the Base
Next comes the base. Crushed rock is wheeled in and spread across the excavated area. The crew rakes it smooth and shapes a slight slope for drainage, then runs a plate compactor over it. This step may be repeated in layers until the base is firm and even.
Getting the base right takes time, and it is not the part to rush. A firm, well graded base is what keeps the turf flat and lets water drain. Some crews add a weed barrier at this stage, depending on the site and product.
Laying Turf and Finishing
Turf rolls are unrolled across the base with all the blades leaning the same direction, which keeps the color consistent. Where rolls meet, the crew lines up the edges and joins them with seam tape and adhesive. The turf is trimmed to fit along borders and fastened around the edges.
Finally, infill is spread across the surface and worked into the fibers with a power broom. The broom also stands the blades up and blends the seams. The crew cleans up, hauls off leftover material and walks the finished yard with you.
After the Crew Leaves
Give the infill a few days to settle and brush any spots that look flat. Keep heavy furniture off fresh seams for a little while. If you are planning an install of your own, we can connect you with an independent local turf provider who works in Arvada.
